盐城、常州、苏州代理罗门哈斯AMBERJET UP6150详细介绍

AMBERJET UP6150 is a fully regenerated mixed
bed of cation and anion exchange resins
intended for use in high purity water systems
after reverse osmosis. In properly designed Ultra
Pure Water systems, Amberjet UP6150 will
deliver 18 Megohm·cm quality water with TOC
levels well below 5 ppb on its first operating cycle
as a polishing mixed bed.
This mixed bed product is particularly suitable
for use in the polishing of high purity water for
specialty electronics applications such as the
manufacturing of disk drives, display devices, CDROMs,
discrete semiconductor devices, lower
density IC chips, or in the back-end chip dicing
and mounting operations. Because of its high
level of regeneration Amberjet UP6150 is also
suited for any general purpose mixed bed
applications for the economical production of
high purity water.
The component resins of AMBERJET UP6150
are uniform particle size Amberjet resins, and
their size was selected to provide excellent first
cycle mixed bed performance, while at the same
time allowing for future separation and
regeneration of the resins. The resins are mixed
to give a stoichiometric equivalent of cation and
anion exchange capacity, and the resin mixture
exhibits no clumping. The uniform particle size
of the resins maximizes kinetic performance in
the service cycle of the mixed bed, while still
allowing for later separation and regeneration.
All these characteristics are essential to produce
high purity water with a minimum volume of
rinsing.
BASIC RESIN PROPERTIES
For high purity regenerated mixed beds, UPW
performance is much more significant than basic
resin properties. It is still important to know that
the resins used in the application are of the
highest quality. The typical properties of the
resins used in AMBERJET UP6150 are shown
below.
These values are listed to show that both the
cation and anion resins used to make AMBERJET
UP6150 meet the standards for high capacity,
uniform particle size ion exchange resins.
Cation H + Anion OH
–
Moisture holding capacity, %_________________ 44.0 - 54.0 54.0 - 64.0
Total exchange capacity, eq/L ________________ ≥ 1.8 ≥ 1.00
Harmonic mean size, μm _____________________ 580 to 680 580 to 690
Uniformity coefficient _______________________ ≤ 1.20 ≤ 1.25
H form % of sites ________________________ ≥ 99 -
OH form % of sites ________________________ - ≥ 95.0
Cl form, % of sites ________________________ - ≤ 0.5
CO3 form % of sites ________________________ - ≤ 5.0
SO4 form % of sites ________________________ - ≤ 0.1

SUGGESTED OPERATING CONDITIONS FOR BEST RESULTS
(Product may be operated successfully outside these conditions, but results may not be optimum)
Feed water temperature______________________ 15 to 25°C (60 to 77°F)
Minimum bed depth ________________________ 900 mm (3 feet)
Service flow rate (working mixed bed) _________ 20 to 30 BV*/h
Service flow rate (polishing mixed bed) ________ 30 to 40 BV/h
Recommended influent water quality
for polishing mixed bed application
Inlet Resistivity ____________________________ > 16 MΩ·cm
Inlet Silica ________________________________<5 ppb
Inlet Total Organic Carbon _________________<20 ppb
* 1 BV (Bed Volume) = 1 m3 solution per m3 resin (1BV/h = 0.125 gpm/ft3)

离子交换树脂